The Options->MM9600 Options was:

(I dont think this options is relevant when changing the bootloader only)

Here is how I did the bootloader change (When I finally got it to work....)

First I set up the device = MM9600(CI1.06) like the screenshot below.
A valid software file is required or else a missing file error will occur ( even if
only bootloader is selected for upgrade)

Then I linked Transbox-Loader into the bootloader ( with out this linking it don't seem to work !!!).

After that I clicked on the Start button and I was asked to reboot the Nokia. After Nokia reboot the serial
patching started and the Bootloader B2.00unS with turbo loader added was loaded into the bootsector.

After the change was completed I wanted to remove the turboloader from the bootsector.

Then the device was set to MM9200(B2.00unS) and linking was unticked in Patches option

Next step is to hit the H-Write button (screenshot below) and do as told by messages from the
software ( it ask for a Nokia reboot- after that is done it should show some serial activities in the
Box Display).

Turn the Nokia off. Click the Start button.

Click connect and then turn the Nokia on AFTER connect is clicked.

Then it should look like screenshot above. Hit the H-Write to reload B2.00unS without
the turboloader linked into the bootloader.

With B2.00unS inside the box I used Nokia Serial Download Server to load DVB2000.

If your using WIN NT or WIN2000 you might have to install TOTALIO or else the Transbox Pro might not work.

Guide to install TOTALIO is found here  http://www.satellite-calculations.com/Satellite/dvb2000/how_to_install_totalio.htm 

2002 Jens T. Satre